My friend "volunteered" to be president of the Winter Sculling Association, so what to do to mark the occasion? Well here's something to add to the Glenn Alsop award for Volunteers:
BRO Magnon in a demonic form - started as a sketch and then I thought about how to make it.... at first I thought I'd make the foray into three scanning so I contacted Thinglab.
They were very helpful and I learned a lot. I'll be using them on a future job - but not this one. Here I went the standard way via plasticine/clay on glass:
Then to the shops for the silicone rubber, two part casting resin and copper powder. It was so cold it took 24 hours for the silicone to set off - not the 6 to 12 promised on the box.... such is life.
Then figuring how much resin to mix to fill the mould just the right amount. didn't want water in this one so the standard displacement wasn't available. Well the guess was OK and after an overnight set it was get to with abrasive pads until it looked the real deal.
Maybe it's not demonic enough... maybe the winter weather isn't as ferocious as it could be..... happy sculling!
No comments:
Post a Comment